A brown-black-red-gold resistor measures 1.18 kΩ after one lead is isolated. What is the best conclusion?
Answers
AIt is outside its ±5% tolerance and should be investigated or replaced
BIt is within tolerance because any value below 2 kΩ is acceptable
CThe gold band means ±20%
DThe meter reading proves the resistor is exactly correct
The answer and explanation are in the full bank.
This question is one of 2,831 in the paid banks. Each comes with the correct answer and the reasoning behind it, not just a mark.
Unlock for 5,000 RWFMIFOTRA exam practicealigned to Technical Foundations·4 marks·Hard
More Electrical Circuits questions
- A facility installs a large capacitor bank at the main switchgear to improve a lagging power factor of 0.75. After installation, they notice high transient overvoltages and VFDs tripping on overvoltage during off-shift hours. What went wrong?
- An industrial plant has a true power of 400 kW and an apparent power of 500 kVA. What is the plant power factor, and is it lagging or leading if the load is primarily induction motors?
- A consultant recommends adding capacitors to a motor control center. What is the primary financial benefit of correcting a poor power factor in an industrial facility?
- A synchronous motor is operating in a plant. The operator increases the DC excitation field current above the normal level. What effect will this have on the plant electrical system?
- When a system has a power factor of exactly 1.0 (Unity PF), what is the relationship between the voltage and current waveforms?
- You measure the voltage on a 3-phase wye-connected system. The line-to-line voltage is 480V. What should the line-to-neutral voltage measure?
- A 3-phase delta-connected heater has three heating elements, each with a resistance of 10 ohms. The line voltage is 480V. If one element burns out (opens), what happens to the total heat output?
- A 3-phase, 4-wire wye system is supplying a heavily unbalanced lighting load. You measure 15A on Phase A, 10A on Phase B, and 0A on Phase C. Will there be current on the neutral wire?