Topics / Electronics & Automation
During a workshop assessment, the reported condition is: An RC low-pass filter attenuates a desired signal because the chosen cutoff frequency is far below that signal. What should be adjusted?
Answers
Ashort the output to ground
Bincrease both values without calculation
Cremove the signal source
Dselect R and C so the cutoff passes the desired band while rejecting unwanted higher frequencies
The answer and explanation are in the full bank.
This question is one of 2,831 in the paid banks. Each comes with the correct answer and the reasoning behind it, not just a mark.
Unlock for 5,000 RWFMIFOTRA exam practicealigned to Technical Foundations·1 mark·Easy
More Electronics & Automation questions
- During troubleshooting, which explanation of MOSFET is accurate?
- During troubleshooting, which explanation of NOT gate is accurate?
- A beginner asks about binary number system. Which answer should you give?
- A beginner asks about thermocouple. Which answer should you give?
- A beginner asks about PLC scan cycle. Which answer should you give?
- What is the best technical explanation of binary number system?
- In a technical interview, what is true about verification of zero energy?
- What is the best technical explanation of semiconductor diode?